Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
TRANSFER PRESS PROBLEM 1
- Thread starter Jscott30
- Start date
-
1
- #2
Basically not very easily, shimming is the easiest option. Another option is to have the form jaws a set distance oversize and drive the final small amount in with wedges or cams this way by taking weight off the press the gap increases, this does however mean that you cannot bottom out the stripper/pad.
Have you considered getting tighter tolerances on the stock material?
Have you considered getting tighter tolerances on the stock material?
- Status
Similar threads
- Locked
- Question
- Locked
- Question