chandra sekar
Mechanical
Do anyone have the timing details of the flange torquing or tensioning for all flange sizes for the purpose of shutdown planning and execution. If anyone have those details, please share it.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
torquing (or) tensioning timings for all flange sizes
- Thread starter chandra sekar
- Start date
- Status
Bolt torque used in fanged joints depends on required gasket clamping force. If you are asking for plant wide advice, you should try a resource like the Garlock Gasket Calculator.
More Information = better answers
More Information = better answers
LittleInch
Petroleum
I think the OP wants a ROT or guide on how long it takes to properly torque up different sized flanges. Which I guess also varies by flange class.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
- Status
Similar threads
- Locked
- Question
- Question
- Question