I have been trying to figure out a way to pass the length of a tool in CATIA using variable %MFG_OVERALL_LGTH into a GUD on a Siemens 840d controller. Does anyone know the syntax to use in a Post-Processor instruction? This is to be used on the machine to compare the active set length to the programmed set length. Thanks in advance
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
TOOL LENGTH TO MACHINE GUD
- Thread starter kb1977
- Start date
Similar threads
- Locked
- Question
- Locked
- Question