Tolerancing grayed out on drawing when adding & modifying hole dimensions

[borsht]

I have a part with a hole wizard hole. On it's respective drawing, I'm trying to add a tolerance to the hole. I click on the "Hole Callout" dimension and under the Tolerance/Precision selections, None, and .125(document) dropdowns. Both are are grayed out, and not drop down-able.
I've also tried adding standard "Smart Dimensions", but they have the same issue on the hole wizard holes. I can however add tolerance to a linear dimension.

Has anyone any advice to fix this issue?


SolidWorks Newbie since 2001
-Currently using SW2021

Inventor Newbie since 2019
-Unfortunately Currently using Inventor22

 

[SBaugh]

Ensure your "Hole callout format file" is where the path is also set in your system options. Make sure large assembly mode is turned off

Otherwise, it might be a setting controlled by your admin if you have one.

Hopefully, you can access the SW forum through their new crappy site:

https://r1132100503382-eu1-3dswym.3...qKdgY7-jbZPg/iquestion:5JodtpF6Q_eI08nYW1H80Q

Scott Baugh, CSWP
Mechanical Engineer
Ciholas

https://www.ciholas.com/

"If it's not broke, Don't fix it!"

faq731-376