Jul 27, 2004 #1 adicm Mechanical Joined Dec 4, 2003 Messages 39 Location MX Hi. It is possible to add a tolerance in a counterbore or countersink hole callout? I need to make a counterbore hole, but with tolerances, and I don't know if this is even possible. THank You Adi
Hi. It is possible to add a tolerance in a counterbore or countersink hole callout? I need to make a counterbore hole, but with tolerances, and I don't know if this is even possible. THank You Adi
Jul 27, 2004 #2 Standing Mechanical Joined Jan 14, 2002 Messages 1,578 Yes, somewhat. You can put +/- (use variable) in the text box, then put .002 after it. Bradley Upvote 0 Downvote
Jul 27, 2004 #3 SBaugh Mechanical Joined Mar 6, 2001 Messages 6,691 Location US Not possible in SW04 - Wait till SW05 - you like that new functionality. Regards, Scott Baugh, CSWP http://www.3dvisiontech.comhttp://www.scottjbaugh.com If you are in the SW Forum Check out the FAQ section To make the Best of Eng-Tips Forums FAQ731-376 Upvote 0 Downvote
Not possible in SW04 - Wait till SW05 - you like that new functionality. Regards, Scott Baugh, CSWP http://www.3dvisiontech.comhttp://www.scottjbaugh.com If you are in the SW Forum Check out the FAQ section To make the Best of Eng-Tips Forums FAQ731-376