Through Curve Mesh From Point To Point in NX7.5

[PSI-CAD]

I often use the tips shown in the attached part to avoid singularity point in Through Curve Mesh starting with one point

I am looking for another method to create the surface in one step

Thanks in advance


Regards
Didier Psaltopoulos

http://www.psi-cad.com

 

[JohnRBaker]

What's wrong with the original Surface 'Through Curve? Mesh'? It's perfectly valid. Those ends where you've selected 'points' are technically not singularities (trust me, if they were, NX would not have allowed the B-surface to be created).

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[PSI-CAD]

Hi John,

This example is very simple for explain the method. Maybe the Term "singularity' is too hard.

Two problems may occur

- machining along iso-parametric should give a wrong quality
- unable to apply thicken

Have you another method, maybe with styled sweep ?


Regards
Didier Psaltopoulos

http://www.psi-cad.com