I have a problem scaling textures in SW2004.
The slider allow for some scaling, but not by far enough.
It seems SW is starting out with the total size of the assembly as a reference, and automatically adjust the texture to what it thinks is all right. This would be ok if I only could ajust the size properly afterwards, but it only allows for something like 2x ajustment.
Anyone with a quick fix ?
Any input appreciated, I am under time pressure here.
The slider allow for some scaling, but not by far enough.
It seems SW is starting out with the total size of the assembly as a reference, and automatically adjust the texture to what it thinks is all right. This would be ok if I only could ajust the size properly afterwards, but it only allows for something like 2x ajustment.
Anyone with a quick fix ?
Any input appreciated, I am under time pressure here.