Well... It's taking a bit of "tweaking" but I am getting it to work. I'm trying to wrap a long line of characters around a short surface. I kept getting errors, so I thought I'd break up the wording and apply it in several places around the angled surface. I managed to get the first part applied, but the second portion, which is shorter than the first (on a new plane, but using the same arc parameters (radius, positioning, etc.)) will not work. I keep getting the following message:
"Wrap only allows one or more closed countours that are disjoint in a sketch"
What the heck does that mean? Solidworks sure likes to use "disjoint" in all their messages.... Can someone elucidate me on the meaning of this?
Thanks.