Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Teamcenter
- Thread starter deerkill
- Start date
DesignJunkie
Aerospace
Deerkill,
Not that I know of. But then again, your problem might be that you, sir, are a pirate! Arrrrr! Good luck with ye Team Center problem!
Not that I know of. But then again, your problem might be that you, sir, are a pirate! Arrrrr! Good luck with ye Team Center problem!
claireandmabel
Automotive
assuming that you are working in NX.far as I know, you can only change Item type (of a part file)in NX. File->New->New Item type and change the selection.
claireandmabel
Automotive
I'm sorry, I mis typed. Open the file in NX, then select File->Save As->New Item type and select the item type you need.
- Status
Similar threads
- Locked
- Question