Tapped Hole in Configurations

[MnInShdw]

Is there any way to change the size of a tapped hole in a configuration?

I have a part with 3 configurations : A - B & C
I need to change the size of a tapped hole in these 3 configurations.

Configuration A should come with a M4 tapped hole.
Configuration B should come with a M6 tapped hole.
Configuration A should come with a M10 tapped hole.


Any kind of help is much appreciated.

 

[MnInShdw]

I found the solution here:

http://help.solidworks.com/2011/Eng...onfiguration/Hole_Sizes_in_Configurations.htm