Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
sum of the principal stresses in ansys / workbench
- Thread starter lonlyboy
- Start date
Hi,
In workbench you can use "user defined results". In expression write S1+S2+S3, (S1+S2+S3 are the principal stresses).
Then you will able to plot the sum of the principal stresses and find where it is located the maximum value.
If you want to know available expressions, clik on Solution and then above on worksheet button. A list with all available commands will be shown.
In workbench you can use "user defined results". In expression write S1+S2+S3, (S1+S2+S3 are the principal stresses).
Then you will able to plot the sum of the principal stresses and find where it is located the maximum value.
If you want to know available expressions, clik on Solution and then above on worksheet button. A list with all available commands will be shown.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question