Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Suitability of ASTM A216 Gr WCB for service
- Thread starter Tatts
- Start date
ASTM STANDARD RELATED BOOK TO STEEL PIPING, TUBING,& FITTINGS WILL BE A GOOD REFERANCE TO YOU .
ASTM A216 : IT HAS THREE GRADE AS WCA,WCB&WCC ,IT COVERS CARBON STEEL CASTINGS FOR VALVES, FLANGES,FITTINGS FOR HIGH TEMPERATURE SERVICE .
GR. WCA GR.WCB GR.WCC
YIELD POINT 30000 36000 40000
MIN (PSI)
ASTM A216 : IT HAS THREE GRADE AS WCA,WCB&WCC ,IT COVERS CARBON STEEL CASTINGS FOR VALVES, FLANGES,FITTINGS FOR HIGH TEMPERATURE SERVICE .
GR. WCA GR.WCB GR.WCC
YIELD POINT 30000 36000 40000
MIN (PSI)
Check Chemicl engineering Hand Book (Perry) this gives usability of various material in various media. WCB is a common CS material, if you could get hold of ASME Sec II D then you could get the allowable stresses at different temperatures for designing purpose. Also ANSI B 31.3 could provide you with necessary information.
If you do not have Chemical Engineering Hand Book give the application i'll try to look and post you.
Good Luck
If you do not have Chemical Engineering Hand Book give the application i'll try to look and post you.
Good Luck
- Status
Similar threads
- Locked
- Locked
- Question
- Locked
- Question
