Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Stress analysis of box structures

Status
Not open for further replies.
SewardWyon

SewardWyon

Mechanical
Apr 6, 2009
3
Does anyone know of a good book or website that details the steps in designing / analysing the stress in box structures?

Many thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Just realised I might have put this thread in the wrong category. Ah well, any help appreciated.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

grantmech
  • Locked
  • Question
Bolted Joint Bending Analysis 2
2
Replies
20
Views
1K
dik
dik
IdanPV
  • Question
Welding of S355JR
Replies
1
Views
272
kingnero
kingnero
GOSP75
  • Locked
NDT req for butt weld bottom plates where no annular plates small diameter API 650 tank .RT is required or Vacuum box testing is enough.
Replies
5
Views
5K
HTURKAK
HTURKAK
RonOz
  • Locked
  • Question
Should pipe based structures (RHS SHS CHS) be sealed or have their ends left open? 1
2
Replies
20
Views
2K
RonOz
RonOz
mrmalcolm
  • Question
Manufacture and testing of welds — Production test
Replies
13
Views
9K
r6155
r6155

Part and Inventory Search

Sponsor

Back
Top Bottom