T
tetrismaster
Guest
Hi everyone! First time poster, looking forward to joining
this community of experts!
I'm trying to create a STL file of a PCB assembly for our
3D printer, but I was told that the nature of IDF files
means there's a gap between the components and the PCB so
after the bath, all the components will fall off.
He mentioned a way to completely solidify the file
(simplified rep?) to make sure everything stays attached.
Do any of you have experience on this? THANKS!!
this community of experts!
I'm trying to create a STL file of a PCB assembly for our
3D printer, but I was told that the nature of IDF files
means there's a gap between the components and the PCB so
after the bath, all the components will fall off.
He mentioned a way to completely solidify the file
(simplified rep?) to make sure everything stays attached.
Do any of you have experience on this? THANKS!!
