When i draw a square plate in sheet metal and select a hole to be placed on to the selected plate the hole just follows the cursor around the plate, why aren't the green alignment lines or cross hairs located through the cursor automatically turned on so I can dimensionally place the hole.? I am a complete novice so I thanks in advance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
St3 no alignment lines ?
- Thread starter obby65
- Start date
fredericmenage
Mechanical
Or you can press F3 when the plane highlights (or left-click on the lock icon on the plane).
This is synchronous behaviour.
This is synchronous behaviour.
- Status