kidari
Mechanical
- Jul 26, 2011
- 3
"ERROR ! One or more spot welds shares a common node.
For example, node 159 appears in more than one spot weld. The model should"
The ANSYS message reads like the above.
could anyone tell me what i am not doing right?
what is causing the problem?
it seems like a meshing problem. one lucky mesh didn't cause any problem and i was able to finish the problem. dose this mean meshing differently is the only solution?
For example, node 159 appears in more than one spot weld. The model should"
The ANSYS message reads like the above.
could anyone tell me what i am not doing right?
what is causing the problem?
it seems like a meshing problem. one lucky mesh didn't cause any problem and i was able to finish the problem. dose this mean meshing differently is the only solution?