I'd like to know if it's possible to split a hole table into two parts. I know this is possible with an (Excel based)BOM in the control properties, but I don't see anything like this for the hole chart. I've got an extra long table showing x's & y's so I'd really appreciate some tips. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Splitting Hole Tables
- Thread starter MimiN63
- Start date
You have to highlight the entire row in SW04, unlike the BOM were you can RMB a single cell and get that option.
Regards,
Scott Baugh, CSWP![[borg2]](/data/assets/smilies/borg2.gif "[borg2] [borg2]")
faq731-376
Regards,
Scott Baugh, CSWP
faq731-376
- Status
Similar threads
- Question
- Locked
- Question