specs for JIS standard

[JonWade]

I am looking to find dimensional and cross referencing info on the following drawing note: "center hole should be according to JIS B 0041-A1. b/3.35"

Any help would be appreciated.

 

[johnwm]

http://webstore.ansi.org/ansidocstore/dept.asp?dept_id=2000

Good Luck
johnwm
________________________________________________________
To get the best from these forums read faq731-376 before posting

Steam Engine enthusiasts:

http://www.essexsteam.co.uk

 

[jsummerfield]

This is the Japanese Standards Association document titled Technical Drawings - Simplified Representation of Centre Holes - ISO 6411. ISO 6411 is an international standard available in multiple languages via several national agencies including AFNOR, BSI, Cenelec, CNIS, DIN, DS, ISO, PSB, SFS and SN, mostly with the ISO number 6411.




John