Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

specification for 1 up to max 3 threads - windings above the nut 1

Status
Not open for further replies.
18081953

18081953

Industrial
Joined
Mar 15, 2005
Messages
4
Location
NL
Dear, ''normal'' we use 1 till max. 3 threads / windings above the nut, for / under normal conditions. But in which specification ASME, DIN, API etc. is this been noted. I can't find it, your help is wanted.

regards,
Herman Siebenhaar
 
Sort by date Sort by votes
For taper threads look in ASME B1.20.1 Part 3.1.7 and Table 2
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

P
  • Locked
  • Question Question
General tolerance specification issue
Replies
7
Views
3K
dtimberlake
D
D
  • Question Question
about ASME Angle JOINT UW-3, UW-12 ?
Replies
4
Views
6K
r6155
r6155
R
  • Question Question
Minimum required thickness for PAUT for process piping
Replies
2
Views
4K
Andrew ONeill
Andrew ONeill
O
  • Locked
  • Question Question
points to capture on a 3D measurement
Replies
4
Views
2K
IRstuff
IRstuff
ishtechmech
  • Question Question
PWHT MULTIPLE TIMES ON THE SAME JOINT OF SA335P91 MATERIAL
Replies
9
Views
20K
Dhurjati Sen
Dhurjati Sen

Part and Inventory Search

Sponsor

Back
Top