yellowtruck
Industrial
I am trying to properly trim a weldment intersection however it is not doing what I want it to.
As you can see below "Allow extension" creates the extra bit of material at the end of the weldment, which is not desired !
However without "allow extension" the "concave" corner is square, and I need it rounded like in the other pic.
Any clues ?
Allow extension
Link
no-allow extension
Link
As you can see below "Allow extension" creates the extra bit of material at the end of the weldment, which is not desired !
However without "allow extension" the "concave" corner is square, and I need it rounded like in the other pic.
Any clues ?
Allow extension
Link
no-allow extension
Link
