getting use to Catia fast but coming from Solidworks its not as friendly. Q. Is there a Equal contraint? when doing sketches and such I use to like to draw the circles or other geo and the geo that was alike I would click all the geo and add a equal constraint. Cannot seem to find it.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Solidworks to Catia 5
- Thread starter wmFLIPPER
- Start date
- Thread starter
- #21
wmflipper - as I stated in a previous post. Design tables allow you to have many configs of a file. You need a parameterized part and a table build in excel or notepad (i prefer excel) to drive the part.
Go here
look up Parameters&DT with macro
download this example.
Regards,
Derek
Go here
look up Parameters&DT with macro
download this example.
Regards,
Derek
- Status
