I am trying to make a general arrangement drawing of a large assembly which contains about 2000 parts and subassemblies. due to the computer (although with the correct and uptodate hardware etc) becomes slow. I was hoping opening assembly is large assembly mode helps but no gain. does anyone know any setting in solidworks 2010 that can assist making faster drawings.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
solidworks drawings
- Thread starter SW2010
- Start date
- Thread starter
- #3
When you go to File->Open, you can choose to open in Quick View or lightweight.
I suspect, though, that your computer is a bit short on power. Go to Start->Right click on 'My Computer', then properties. You'll see your system specs there; OS, Hard Drive, RAM, etc. Let us know what it says.
Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog
I suspect, though, that your computer is a bit short on power. Go to Start->Right click on 'My Computer', then properties. You'll see your system specs there; OS, Hard Drive, RAM, etc. Let us know what it says.
Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog
- Status
Similar threads
- Locked
- Question
- Locked
- Question
