Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Solid Edge Draft Document 1

Status
Not open for further replies.

Mick72

Mechanical
Joined
Jan 23, 2009
Messages
4
Location
US
Hello All

Could someone help me with the following.

On any draft document that I create, when I am dimensioning a hole, I get a thick circle instead of a diameter symbol, also any GD&T symbols such as flatness I get a lowercase (r).

Any assistance anyone and everyone can provide will be forever appreciated.

Thank you

Your friendly neighborhood drafter.
 
As this is more a CAD problem, it would be better to post it here --> forum562
Good luck!

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top