snapping 2 tables together

[wildmodeler]

Is there a way to make a table snap to the corner of another table? We have 2 tables that are supposed to line up with each other. Can this be done?

 

[telecomguy]

The way I do it is I set my drawing grid to .05" x .05" and then make sure all of my tables are a multiple of .05" wide/tall. This way they'll always behave properly.

 

[dr_gallup]

Or you can just zoom way in and place them by eye. As a perfectionist I used to abhor this, wanting them to be perfect, but in reality you can get them way closer than the width of a printed line, visually the hard copy is perfect. I stopped sweating insignificant details like this years ago.