Snap beahviour in NX8

[HynfiNX]

I would like to know if there's a way to adjust or change SNAP beahaviour in NX8. I would like it to work as it used to be in NX4.

For example, in NX4 I could pick the END (or MIDDLE point) of a line just moving the cursor near the END of the line. I didn't have to be exactly over the END, just somewhere along the line, near the end.

In NX8 I have to place the cursor exactly over the END of the line if I want the SNAP to activate. This slows down my workflow alot. Is there any way to change this behaviour ?



Mold designer
Italy

 

[helperug]

There is a special snap point toggle to active in the selection/point snap toolbar.

sorry new in NX
regards
Erwin

 

[PSI-CAD]

Don't forget also to toggle off the point on curve option


Regards
Didier Psaltopoulos

http://www.psi-cad.com

 

[HynfiNX]

Thank you, it works

Is there any way to turn off that small coordinates window when creating the line ?!

Mold designer
Italy

 

[PSI-CAD]

Yes, just press F3
One more hide also the menu
One more to show all windows


Regards
Didier Psaltopoulos

http://www.psi-cad.com