Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Smoke/Fog for Finding Leaks in Piping

Status
Not open for further replies.

RJB32482

Chemical
Jan 19, 2005
271
Hello,
I am wondering if anyone knows a good vendor or company that either performs the task of fogging pipes to find leaks or sells fog machines to do the task. The pipe probably will not hold up if water is introduced into the system and also the material sent through the piping is food grade, so contaimination could be an issue. Any food grade "smoke" leak detectors out there?

Thanks
 
Replies continue below

Recommended for you

I don't think a smoke bomb is your answer since if will only detect an open ended pipe. Smoke is generally use for air conditioning, sewer lines, and line mapping. I don't think the products of a smoke generation device would be food grade.
You say your line want hold up under the weight of water seems very strange. Are all the process materials gaseous?

The are numerous ways to test your system, pressure decay, pressurization with some gas and detect the gas, pressurize with air and check with leak detector fluid, pressurize with a gas and use an ultrasonic detector.
There are plenty of companies that do any or all of the above and none except the He test is out of your realm of possibility doing it yourself.

Come back with a little more information.
 
Thanks,
All of the process materials are very light (beads at a bulk density of 41 pcf). The piping inspector at our plant doubts the line will hold full of H2O.

The line is exiting a Fluidized Bed Dryer and airveying the dry beads for about 200ft-300ft of 4" Schedule 80 piping into a cyclone. So if we break the line after the dryer and smoke the piping, couldn't we find the leak? Most of the piping runs about 80ft vertically, so its hard to get to.

Thanks
 
1. Airvey a dust of whatever material the beads are made from, and visually inspect for escaping material.

2. Convey a substantial flow of low pressure steam, and visually inspect for escaping steam or water.



Mike Halloran
Pembroke Pines, FL, USA
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor