Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Slotted hole detailing dimensions

Thread starter blackmaddog
Start date Apr 26, 2013

Status: Not open for further replies.

Apr 26, 2013

blackmaddog

Structural

AISC Table J3.3 specifies the standard dimensions of short and long slotted holes. Is the slot length measured out to out or center to center of the radius?

We have one very old reference that shows both options. I don't have a AISC detailing manual to reference.