Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sketch dimension decimal places?
- Thread starter scout67
- Start date
The one setting controls both drafting and sketch dimensions.
This is a good time to use the master model method and set up separate "modeling" and "drafting" template files. This way you can have different options in each.
www.nxjournaling.com
This is a good time to use the master model method and set up separate "modeling" and "drafting" template files. This way you can have different options in each.
www.nxjournaling.com
- Thread starter
- #3
- Status