Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Simulate shock in pipes,

Thread starter admincae
Start date Jul 21, 2012

Status: Not open for further replies.

Jul 21, 2012

admincae

Mechanical

Good morning,

Can somebody tell me if I want to simulate some shock in a pipes when some valves are close in a short time, what type of american standards I can apply?

Somebody can offers me some little support to resolve this problem?

To resolve this problem I will use ANSYS Classic 14.

Thanks in advance for support.

Best regards.

Mess with the best die like the rest...ANSYS is the best !!!