Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
simple extrude between 2 differet diameters 1
- Thread starter GPowers2
- Start date
-
1
- #2
JohnRBaker
Mechanical
Just use...
Insert -> Sweep -> Swept...
...and just select each arc as the start and end Sections, and the spline as the single Guide, as I did in the sample file attached below.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
Insert -> Sweep -> Swept...
...and just select each arc as the start and end Sections, and the spline as the single Guide, as I did in the sample file attached below.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Status
Similar threads
- Question
- Locked
- Question