Simple Diameter

[phillpd]

Same with Simple Radius, but why when the part file is Inch do I get a dialog asking for "Start Point" and "End Point" ?

With a Metric part file, the dialog is asking for "Diameter Object"

NX 6.0.5.3, NX 9.0.2.5
NX 10 (Testing)
Windows 7 64 (Windows 8.1 Tablet)

 

[JohnRBaker]

What exactly do you mean by "Simple Diameter" and "Simple Radius"? These are not the names of NX functions. Where are you seeing this?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[phillpd]

Analysis Tab-->More Gallery-->Simple Diameter

NX 6.0.5.3, NX 9.0.2.5
NX 10 (Testing)
Windows 7 64 (Windows 8.1 Tablet)

 

[phillpd]

The attached image shows the different dialog based on whether the part file is Metric or Inch

NX 6.0.5.3, NX 9.0.2.5
NX 10 (Testing)
Windows 7 64 (Windows 8.1 Tablet)

 

[JohnRBaker]

OK, I see what you mean. I'm opening a PR.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[phillpd]

Thanks John

NX 6.0.5.3, NX 9.0.2.5
NX 10 (Testing)
Windows 7 64 (Windows 8.1 Tablet)