showing individual components in table

[TheGrunt]

First let me apologize since this has probably been brought up before, however, I can't find it. I have an assembly drawing with some sub-assemblies in it and I want to create a table that shows each individual part name (not the names of the sub-assemblies). Is there a way to do this?

 

[looslib]

It is done with the tables repeat region settings. Look at settings for filters and duplicates.




"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.

Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand

 

[Guest0527211403]

To add a bit to Ben's answer- Make sure the repeat region is set to be Recursive under the attributes, so that it can see the parts in your subassemblies.

----------
"By all means, do not use a hammer." (1925 IBM Maintenance Manual)