Butkusrules
Industrial
How do I do it? Can I get the dimensions off of a STEP file created in Inventor 9 in SOLIDWORKS 2003??
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Showing dimensions in SW from Inventor STEP file??
- Thread starter Butkusrules
- Start date
- Status
You can redimension the part in SW, but cannot extract dimensional information from the part. The conversion from native Inventor file format to STEP strips out this information.
[green]"But what... is it good for?"[/green]
Engineer at the Advanced Computing Systems Division of IBM, 1968, commenting on the microchip.
Have you read faq731-376 to make the best use of Eng-Tips Forums?
[green]"But what... is it good for?"[/green]
Engineer at the Advanced Computing Systems Division of IBM, 1968, commenting on the microchip.
Have you read faq731-376 to make the best use of Eng-Tips Forums?
- Status
