W
wannaCAD
Guest
View attachment 2027
Recently installed Inventor 2019.
To my disappointment the names of
the panels at the bottom of the ribbon
are half size (the lower half of the name
does not show). This problem never
appeared in other versions of Inventor
that I have used.
Is there a way to increase the height
of the ribbon so the names of the panels
are whole?
Thanks to anyone who helps.
Recently installed Inventor 2019.
To my disappointment the names of
the panels at the bottom of the ribbon
are half size (the lower half of the name
does not show). This problem never
appeared in other versions of Inventor
that I have used.
Is there a way to increase the height
of the ribbon so the names of the panels
are whole?
Thanks to anyone who helps.
