Sheetmetal forming tool trouble. 1

[dutch7777]

I'm having trouble inserting a forming tool feature
into a sheetmetal part recently. Drag and drop returns an error asking if I'm trying to create a derived part.
I know this worked about a month ago because I did a part with the an emboss feature that I created. Sheetmetal cutouts still work...Don't know if something has broke since then. Any ideas? Reinstall?

 

[SBaugh]

Depends on your material thickness. What is your material thinkness?

Scott Baugh, CSWP

http://www.scottjbaugh.com

faq731-376

 

[dutch7777]

Scott

.048 thick...like I said, this has been working...seems like
something "broke" within the last few weeks...I'm guessin
a reinstall is in order...

 

[sleighcam]

Had the same problem.
1 mail to the support solved it.

Open the design library. Go to the folder with the forming tools.
Right click on it and mark the line "Forming tools Folder".
You can choose the subfolders as also containing forming information.

 

[dutch7777]

Sleighcam,

Thanks...that did it...I remember messing around with
this but couldn't quite figure out it's purpose...any
thoughts...?...Thanks again...