I am a machinery reliability engineer. I am developing a standard for shaft repair. I want to define what sorts of damage to certain areas can be repaired using HVOF, Flame Spray (metalizing), Sleeving, Welding, Belzona, etc. I want to take into account the service conditions of the shaft: wearing area under pump packing, areas under interference fit parts such as impellers, ball bearings or coupling hubs, bearing journals in sleeve bearings, etc. Is anyone aware of existing standards that might be helpful?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Shaft Repair Standard 1
- Thread starter JJPellin
- Start date
The Classification Bureaux have a great deal of knowledge with regard to all types of shaft repair, propeller shafts being a typical area for example. Try Marcus Cridland at ABS London, E-mail 'mcridland@eagle.org'. Other CBs are Lloyds Register, DnV, Bureau Veritas, and so on,
Regards,
Graham Tyler
Regards,
Graham Tyler
-
1
- #3
- Status
Similar threads
- Question
- Question
- Question
- Locked
- Question