Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Selection of Elastomer(material) for API682 seal

Status
Not open for further replies.
ciddik

ciddik

Industrial
Joined
Jun 5, 2003
Messages
22
Location
IN
can anybody help me for the selection of elastomer of mechanical seal for MDEA solution, temp: 50deg C, pressure, 40 bars(max)

the seal design is as per API682.


siddik


siddik
 
Sort by date Sort by votes
You can use EPDM which will be slightly less costly than the alternative, FFKM (perfluoroelastomer). If cost is not a concern, I would recommend Kalrez Spectrum 6375 for this application; I have several seals in this type of service with this grade of perfluoroelastomer and they perform well.
 
Upvote 0 Downvote
A safe bet for a refinery or other hydrocarbon processing facility is the perfluoroelastomer. EPDM generally swells in the presence of hydrocarbon and can inhibit the movement of seal parts or squeeze brittle parts.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

dgeesaman
  • Question Question
Decreasing operating range of seal elements over the years
Replies
0
Views
6K
dgeesaman
dgeesaman
65CCJ
  • Question Question
480 Mpa (69,620 psi) static seal for hydrotesting at Room Temp.
Replies
0
Views
7K
65CCJ
65CCJ
BasakAbhishek
  • Locked
  • Question Question
Sealing of gases by lip type seal
Replies
7
Views
4K
SB1976
SB1976
moon161
  • Locked
  • Question Question
Dry gas instead of liquid for leak test in pump w/ mech seal.
Replies
4
Views
2K
A8yssUK
A8yssUK
R
  • Locked
  • Question Question
Low friction rotary shaft seal for middrive ebike motor
Replies
8
Views
5K
raficzeqq
R

Part and Inventory Search

Sponsor

Back
Top