Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Selection of chained / continuous entities?
- Thread starter strim
- Start date
ortions of seperate surface edge boundries or trimmed wire entities. Similar to the autosearch in sketcher. Is there a way to autosearch construction entities?What would you like to use them for?
Try this in GSD:
Create a new open body
select all the surfaces you need edge curves from
Edit --> search, workbench:topology - type:edge - look:from current selection.
Search and select
Extract with no propogation
Join the curves, pick 1 curve, contextual menu distance propogation or angular propogation - which ever suits
Try this in GSD:
Create a new open body
select all the surfaces you need edge curves from
Edit --> search, workbench:topology - type:edge - look:from current selection.
Search and select
Extract with no propogation
Join the curves, pick 1 curve, contextual menu distance propogation or angular propogation - which ever suits
Hi,
I do think autosearch will work in sketcher.
In GSD when doing a JOIN, select first curve/line then in the dialog bok go right clic on it then select the autosearch propagation you want.
I do think autosearch will work in sketcher.
In GSD when doing a JOIN, select first curve/line then in the dialog bok go right clic on it then select the autosearch propagation you want.
Eric N.
indocti discant et ament meminisse periti
indocti discant et ament meminisse periti
- Status