seeking source for banana jack

[Vanadate]

I am reverse engineering a component and can not find a suitable replacement part. Th part is a 2.5 mm ID/4mm OD tube about 8mm long, bottomed out on one end and flanged on the other. It is used as a banana jack but not sure if that was it's orininal purpose. I have checked pamona, newark, mausser, etc, and no luck. Pomona part 3277 is as close as i have gotten. It is possible the part is a modified version of something stock as it has a spring soldered to bottom. Any help is appreciated. I have attached an image for reference. Thanks

 

[MacGyverS2000]

Blech, DOCX files... one of the many poor decisions MS has made in recent years.

Dan - Owner

http://www.Hi-TecDesigns.com

 

[Vanadate]

Attachment now PDF..

 

[MacGyverS2000]

Looks more like a standard brass ferrule...

Dan - Owner

http://www.Hi-TecDesigns.com

 

[Vanadate]

I does look a lot like a ferrule, but it is bottomed.

Any idea where I might find one?

 

[MacGyverS2000]

I'd probably try a pop rivet manufacturer before looking at electronics...

Dan - Owner

http://www.Hi-TecDesigns.com

 

[Vanadate]

Hum, Checked out pop rivets but I don't see anything in my part that suggest there was a pull rod attached.

 

[mcgyvr]

maybe you can find something at

http://www.mill-max.com/

 

[MacGyverS2000]

I'm not suggesting it was a pop rivet, only that those manufacturers often make ferrules of various shapes/sizes, too.



Dan - Owner

http://www.Hi-TecDesigns.com