Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

section cut for slabs

Status
Not open for further replies.
dudu1

dudu1

Structural
Joined
May 10, 2004
Messages
2
Location
CA
Hi there!
I'm modelling a flat slab in SAP2000, and I need some help in defining section cuts for findind the moments for each strip. Can you tell me how to do it? I think that I'm not selecting the right shells and nodes.Can you explain me?
Thanks.
Dudu
 
Status
Not open for further replies.

Similar threads

a_urbs
  • Locked
  • Question Question
Using Section Cuts in SAP for Storey Weight
Replies
0
Views
1K
a_urbs
a_urbs
BVT
  • Locked
  • Question Question
Sap2000 Section Cut
Replies
0
Views
386
BVT
BVT
J
  • Locked
  • Question Question
Question about the definition of transfer beams in a pile cap for a pedestrian bridge foundation
Replies
0
Views
2K
jcarlosamao
J
juandavidguzman
  • Locked
  • Question Question
SAP2000 Nonlinear Analysis Setup for Steel Design: Notial loads
Replies
2
Views
2K
STpipe
STpipe
A
  • Locked
  • Question Question
CSI BRIDGE "Design request" for Precast Concrete I Girder bridge does not work when the defined beam is nonprismatic !!!
Replies
0
Views
872
Abderrahmane Mche
A

Part and Inventory Search

Sponsor

Back
Top