Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Section curve problem in NX2

Status
Not open for further replies.

AdrianRo

Automotive
Joined
Dec 30, 2002
Messages
16
Location
RO
Hi everybody,

I just start to using UG NX2, and I found a problem with the Section Curve. When I try to section a component in an assembly with a plane, I recieve a message like "It wasn't create any section curve". In other words I can't section no one component. Can everybody give me a hand please?

Thanks !
 
You can't make an associated section on components in an assembly, toggle off "associated ouput" and it will work. If you want an associated section I would use wave or promote the components into the assembly and then make an associated section.
 
That is the problem! I try to make an non associated section, with the filter on the "Body". If i try to section a face of the component it works, but if I try to select a Body, dosen't work....
 
Try View -> Operation -> Section...

It will allow you to create section curves which are associative within an assembly.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top