Fig. UG-34(a) shows a shell thickness (ts) & a head thickness (t) transitioning with a taper. I'm assuming that the figure points this out to show when the shell thickness is thinner than the head thickness, there must be a tapered transition between the two. It's not, however, stating that the shell thickness must always be thinner than the head thickness, correct? (ie ts=t is ok).
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sec VIII Div1 UG-34
- Thread starter HPM3
- Start date
- Status
Similar threads
- Locked
- Question