Hello. I am a power hobbist and I am designing a large vane motor as steam expander. But I do not know how to seal the rotor axial face and the vanes sides to the end plate. I was planning to make the rotor face and the vanes sides as flat as possible and press them against the end plate, which should de made of vespel, hopping to seal while reducing the wear. What do you think? do you have other ideas? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Seals for a vane motor as steam expander
- Thread starter tobak
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Question