I am trying to design a simple blanking die that trims the scrap from the coil edges and shear off the blank. My problem is when I do my scrap design, I can only get one side of the scrap to come in. When I leave a gap between the two blanks, the entire scrap region highlights. But I don't want a gap and waste material. Can anyone with PDW experence help me?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Scrap Design using the Progressive Die Wizard
- Thread starter DieMan44
- Start date
Similar threads
- Locked
- Question
