Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Same level bridle Control & Trip 1

Status
Not open for further replies.
kkimic

kkimic

Petroleum
Joined
Mar 22, 2007
Messages
14
Location
CN
Hi everyone,

I always design a vessel with segregated level bridles, one for controls and the other one for the trips. Is there any API Std where this is mentioned? I am trying to find a reference other than me saying this is the way to do it.

Thanks
 
Sort by date Sort by votes
IMO, this decision is driven by the PHA and LOPA on each vessel/service/scenario.

Good luck,
Latexman
 
Upvote 0 Downvote
Latexman,

Thanks. I thought I had seen it in an API Std but I couldn't find it...

Regards
 
Upvote 0 Downvote
I don't know if it is in an API anywhere but it is definitely an industry best practice.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Pavan Kumar
  • Locked
  • Question Question
Steam Mains Pressure Control Valve Sizing
2
Replies
28
Views
10K
pierreick
pierreick
Jyop92
  • Locked
  • Question Question
Gas Scrubber P&ID
Replies
2
Views
608
1503-44
1503-44
rjd1452
  • Locked
  • Question Question
Level Control Valve Sizing
Replies
3
Views
417
LittleInch
LittleInch
newbestudent
  • Locked
  • Question Question
Distillery set-up & process
Replies
1
Views
442
crshears
crshears
wd1980
  • Locked
  • Question Question
Low liquid level in Compressor Suction scubber
Replies
8
Views
826
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top