Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
safety valve's gag
- Thread starter morojlu
- Start date
The gag is to prevent the valve from lifting during hydro test. In a hydro, you are intentionally overpressurizing the system. The valve is there to PREVENT that. So you gag the valve down (finger-tight) so you can build the pressure well past the valve's setpoint.
MarcelValve
Specifier/Regulator
Hi people,
May I take the opportunity to point out that these test gags should be REMOVED and safely stored during normal operation????
I consider test gags as very dangerous, they should be red labelled and checked upon during start up procedure.
Be aware I have seen them mounted in a full operating plant, scares the hell out of me as people are not aware of their danger! The valve will not open at set pressure with a test gag mounted.
Some manufacturers of safety valves mount them standard as transport protection with the disc screwed down to the seat firmly.....
Get out there, see for yourself if you are safe!
Marcel
May I take the opportunity to point out that these test gags should be REMOVED and safely stored during normal operation????
I consider test gags as very dangerous, they should be red labelled and checked upon during start up procedure.
Be aware I have seen them mounted in a full operating plant, scares the hell out of me as people are not aware of their danger! The valve will not open at set pressure with a test gag mounted.
Some manufacturers of safety valves mount them standard as transport protection with the disc screwed down to the seat firmly.....
Get out there, see for yourself if you are safe!
Marcel
- Status
