Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

S275 JR not in Finglow

Status
Not open for further replies.
dmkd1

dmkd1

Mechanical
Joined
Jan 5, 2012
Messages
6
Location
IE
I am looking to design a vessel with S275 JR steel which is covered by EN 10025-2:2004. However this grade steel is not an option on the Finglow software. Do I use the closest matching material in this case?
 
Sort by date Sort by votes
Steve is correct! S275JR is not for pressure equipment. Try P265GH, or if you need higher strength : P295GH.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jt1234
  • Question Question
Div. 1, UG-37, Correction factor "F" not making sense
Replies
2
Views
3K
Trestala
Trestala
KD007
  • Question Question
SA-193 Gr.B7M bolt material used in Wet H2S service is not passing requirement of UG44b clause.
2
Replies
20
Views
10K
r6155
r6155
Anatoly_k
  • Locked
  • Question Question
Burst Pressure estimation in Ansys. Solver does not stop when failure happens
Replies
11
Views
5K
FacEngrPE
FacEngrPE
MchA
  • Question Question
Support Beam in Skirt Anchor Box
Replies
3
Views
2K
Trestala
Trestala
D
  • Locked
  • Question Question
Unity check in saddle
Replies
3
Views
4K
Shaikh Mohammed Ammar
Shaikh Mohammed Ammar

Part and Inventory Search

Sponsor

Back
Top