.RVT file load to nx11

[Ehaviv]

Hi

is there any way to open or bring .rvt file to nx ?

Thanks

 

[jerry1423]

I don't think so, but there must be an easy way to convert the Rivet file to .dwg or .dxf, which can be imported into NX.

Jerry J.
UGV5-NX11

 

[jerry1423]

There are some convertors that will do it for you.
trying goggling .RVT to NX and you will see some

Jerry J.
UGV5-NX11

 

[Ehaviv]

Thank you Jerry.

Do dwg or .dxf are they 3d solid
When opened in nx.

 

[jerry1423]

I really don't know if they will be brought in as solids or curves

Jerry J.
UGV5-NX11

 

[Ehaviv]

Jerry thank you.
From my experience these formats
Are curves only.

 

[Toost]

3D- dwg can in later versions ( At least NX12) of NX produce good solids.
Siemens has a .rvt->JT converter which can produce solids in some cases. ( It's NOT dependent on the Siemens products in this case, it's all dependent on what Revit exports.)
.dwg has given me way better results than .rvt.

Regards,
Tomas

 

[Ehaviv]

Tomas Thank you for this information.