Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Rubber Properties
- Thread starter butelja
- Start date
I am working on a system using a cylinder of rubber as "fluid" in a jack amplifier
I am looking for pre-designing information on :
- COMPRESSION MODULUS vs SHORE "A" DUROMETER for an "unknown" rubber.
- FRICTION and DAMPING factors
Curves will be wellcomen
Any help would be appreciated.
I am looking for pre-designing information on :
- COMPRESSION MODULUS vs SHORE "A" DUROMETER for an "unknown" rubber.
- FRICTION and DAMPING factors
Curves will be wellcomen
Any help would be appreciated.
Hi
Sorry for the previous answer which was not one
Have a look in :
"Handbook of Mechanical Engineering"
Dubbel
Springer-Verlag ISBN 0-540-19868-7
page F59 §2.3.1 Rubber and its Properties
fig 12 gives a shear modulus for natural rubber in relation to Shora A hardness
Sorry for the previous answer which was not one
Have a look in :
"Handbook of Mechanical Engineering"
Dubbel
Springer-Verlag ISBN 0-540-19868-7
page F59 §2.3.1 Rubber and its Properties
fig 12 gives a shear modulus for natural rubber in relation to Shora A hardness
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question
