I
IanDF
Guest
Hello all,
I have to apply a load case to a truck chassis. This load case consists of the following four individual loads:
A) Roll Load - Linear field around coordinate MAIN (4815,0,1143) which gives 13.9g in vertical direction at y=1125mm.
B) Vertical Load - Vertical acceleration of 2.0g, up/down.
C) Longitudinal Load - Longitudinal acceleration of 6.6g, forward/backward.
D) Lateral Load - Lateral acceleration of 8.0g, in/out.
I'm not sure how to apply the Roll Load (A). Please refer to the picture below for clarification of the above information.
View attachment 2205
All assistance and advice greatly appreciated.
Regards Ian
I have to apply a load case to a truck chassis. This load case consists of the following four individual loads:
A) Roll Load - Linear field around coordinate MAIN (4815,0,1143) which gives 13.9g in vertical direction at y=1125mm.
B) Vertical Load - Vertical acceleration of 2.0g, up/down.
C) Longitudinal Load - Longitudinal acceleration of 6.6g, forward/backward.
D) Lateral Load - Lateral acceleration of 8.0g, in/out.
I'm not sure how to apply the Roll Load (A). Please refer to the picture below for clarification of the above information.
View attachment 2205
All assistance and advice greatly appreciated.
Regards Ian
